Well I finished painting the walls in the garage which has really cut down the dust, so hopefully I can get on with the boat this week.
I have some final shaping to do to the cradle to make sure the boat sits right and is fully supported by all the frames. At the moment the inner of the two rear frames is not touching the bottom of the boat.
The gap is only 2 to 3 mm but to get it to sit down I have mark of the front frames with a marking block and a pencil and take of a small amount of timber at a time with a spoke shave until all the frames make contact. This should cut down the flex went I'm sanding down the inside of the boat.
I'll try to put some photo's on this weekend.